[c-nsp] Fast Reroute - Detour Object support ?

[Asheesh Jadav]

Hi,

   Is the DETOUR Object as specified in RFC 4090 supported on Cisco IOS? I'm
trying to set up a detour through a Cisco 7600 but the system doesn't seem
to like the PATH message. I'm using the  Version 12.2(33)SRB5 on a 7600
chassis.

Router#
Router#
*Sep  5 07:21:10.999: RSVP: Found unknown object (63) when parsing message
*Sep  5 07:21:10.999: RSVP: 7.7.7.7_1->8.8.8.8_1[7.7.7.7]: Found unknown
object (63) when parsing Path message
*Sep  5 07:21:10.999: RSVP: 7.7.7.7_1->8.8.8.8_1[7.7.7.7]: Sending PathError
message to 20.20.20.7
*Sep  5 07:21:11.007: RSVP-MSG: 7.7.7.7_1->8.8.8.8_1[7.7.7.7]: Received
PathTear message from 7.7.7.7 (on GigabitEthernet4/1)
Router#
Router#show mod
Mod Ports Card Type                              Model              Serial
No.
--- ----- -------------------------------------- ------------------
-----------
  4    8  8 port 1000mb GBIC Enhanced QoS        WS-X6408A-GBIC
SAL0735KZKL
  5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B
SAL1208GKQA

Mod MAC addresses                       Hw    Fw           Sw
Status
--- ---------------------------------- ------ ------------ ------------
-------
  4  000d.bdf5.2bbc to 000d.bdf5.2bc3   3.0   5.4(2)       8.6(0.434)BA Ok
  5  0017.9444.2688 to 0017.9444.268b   5.3   8.5(2)       12.2(33)SRB5 Ok

Mod  Sub-Module                  Model              Serial       Hw
Status
---- --------------------------- ------------------ ----------- -------
-------
  5  Policy Feature Card 3       WS-F6K-PFC3B       SAL1126W66V  2.2    Ok
  5  MSFC3 Daughterboard         WS-SUP720          SAL1126W66E  2.3    Ok

Mod  Online Diag Status
---- -------------------
  4  Pass
  5  Pass
Router#


Thanks.

Asheesh