[c-nsp] mls qos vlan based

Arie Vayner (avayner) avayner at cisco.com
Tue May 19 07:32:55 EDT 2009


You need to apply the marking ingress policy on the "interface vlan".
Even if it's a L2 only VLAN, you can do "interface vlan", but do not
have to configure an IP address.

This is documented here:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/con
figuration/guide/qos.html#wp1726124

Arie

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Swati Sharma
Sent: Tuesday, May 19, 2009 09:01
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] mls qos vlan based

Hi,

I am trying to prioritize traffic from certain vlan and send it to
port-chanel. When I do this, it says MQC not supported on channel
interfaces. What is the other way to achieve the same. I want to
prioritize
any traffic from (say) vlan 10 / 20.
Regards,
Swati
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/


More information about the cisco-nsp mailing list