[c-nsp] Cisco 12416 Power Management

[Antonio Soares]

Group,

I'm trying to figure out why i have this output:

++++++++++++++++++++++++++++++++++++++++++++++
12k2>sh env power_supply 

Failsafe power system

Slot #          48V     AMP_48
                (Volt)  (Amp)
27      PEM1    53      10      Failsafe-PEM=   Failsafe PS
        PEM2    No module detected
        PEM3    No module detected
        PEM4    No module detected

12k2>
++++++++++++++++++++++++++++++++++++++++++++++

When i have a similar 12k showing this:

++++++++++++++++++++++++++++++++++++++++++++++
12k1>sh env power_supply 

DC Power Supplies

Slot #          48V     AMP_48
                (Volt)  (Amp)
27      PEM1    52      4       PWR-GSR16-DC=   Standard DC PS
        PEM2    52      7       PWR-GSR16-DC=   Standard DC PS
        PEM3    54      16      PWR-GSR16-DC=   Standard DC PS
        PEM4    55      20      PWR-GSR16-DC=   Standard DC PS

12k1>
++++++++++++++++++++++++++++++++++++++++++++++

Both 12k's have 4 2000W DC Power Supplies.

The only thing i was able to verify is that in 12k2, Zone 2 Power Consumption is above 2000W. Could this lead to the apparently
abnormal situation above ?


Thanks.

Regards,

Antonio Soares, CCIE #18473 (R&S)
amsoares at netcabo.pt