[c-nsp] cisco 4503 port security

[Dracul]

Thanks Arie,

I was trying to do a port that is trunked then apply port-security. I think
this doesn't give the option. The only next thing to do
perhaps is to try it with access-list or pvlan? But the the thing with pvlan
is, will it complicate the config using other vlans
on top of that?

regards,
chris


On Tue, Sep 8, 2009 at 4:02 PM, Arie Vayner (avayner) <avayner at cisco.com>wrote:

> Chris,
>
> This is the latest config guide:
> http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/conf
> iguration/guide/port_sec.html<http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/conf%0Aiguration/guide/port_sec.html>
>
> Could be some older IOS or low end SUP?
>
> Arie
>
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Dracul
> Sent: Tuesday, September 08, 2009 10:51
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] cisco 4503 port security
>
> Hi List,
>
> has anybody experienced doing port isolation / port-security using the
> cisco
> 4503?
> I can't seem to find the best way to do it since the IOS doesn't have
> port-security option in the CLI.
>
> regards,
> Chris
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>