[c-nsp] Weird Cat 6500 SUP2 problem

[Howard Leadmon]

 Make sure you have the bootvar's set right and the config register also
correct on both SUP's, as I  once had a SUP2 that wouldn't boot, just to
find out the confreg on the spare was not right, so it was just dropping to
ROMMON..


---
Howard Leadmon 


> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-
> bounces at puck.nether.net] On Behalf Of Security Team
> Sent: Thursday, September 10, 2009 5:44 PM
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] Weird Cat 6500 SUP2 problem
> 
> I am setting up a 6509 with SUP2's in RPR+ redundancy mode.  When I cycle
> power on both supplies, the top SUP2 comes up fine. But the bottom one is
> stuck in rommon
> 
> If I type "b" to boot the second one it comes up fine.
> 
> Am I doing something stupid?
> 
> Thx,
> CJ
> 
> 
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/