[c-nsp] Problems creating a new BGP neighbor

[Mihai Campean]

Hi Chris,
I reloaded the box this morning, but I'll configure the command in order 
to prevent further issues :)
Thanks:)

Chris Mason (chrimaso) wrote:
> Hi Mihai,
>
> Check out CSCsz68307 - this occurs when someone attempts to configure an invalid IP address as a BGP peer - after that you are unable to create any additional peers as you get the error message "*% Create the peer-group first".
>
> To resolve the problem you either need to reload the box or configure "no parser cache" - the latter being more preferable.
>
> Hope that helps,
> Chris
>
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Mihai Campean
> Sent: 14 September 2009 14:34
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] Problems creating a new BGP neighbor
>
> Hi,
> today I tried to create a new bgp neighbor, and the following message 
> was prompted:
> router1#conf t
> Enter configuration commands, one per line.  End with CNTL/Z.
> router1(config)#router bgp 1235
> router1(config-router)#neighbor 1.2.3.5 remote-as 1235
> *% Create the peer-group first
>
> *Has anyone encountered this?
> The machine is a 7600 series router, running Cisco IOS Software, 
> c7600rsp72043_rp Software (c7600rsp72043_rp-ADVIPSERVICES-M), Version 
> 12.2(33)SRC1, RELEASE SOFTWARE (fc1)
> Any ideea if this is a known BUG, and if there is some command on the 
> IOS that forces you to add a new neighbor to a peer-group?
> Thanks,
>
>   

-- 
Best regards,

----------
Mihai Campean