[c-nsp] Cisco 7200 - IOS15.1 - Port-channel

[Jason Berenson]

Well, I downgraded to the latest 12.4 (c7200-is-mz.124-25c.bin).  Same 
symptoms.  Any ideas?  I tried removing the port-channel and re-adding 
too, no luck.

-Jason

On 4/12/2010 3:30 PM, Jason Berenson wrote:
> Greetings,
>
> I just upgraded a Cisco 7206 NPE-400 to: 
> c7200-advipservicesk9-mz.151-1.XB.bin from the latest 12.4.  I've got 
> a port channel and it removed the 'channel-group 1' line from the two 
> ethernet interfaces.  When I try to add them back I get:
>
> router(config-if)#channel-group 1
> Error: This interface does not allow user-settable mtu.
>  Remove the mtu command from the port channel configuration
>  to be able to add this interfaceto the port channel
>
> I don't have any mtu commands on any interfaces except the defaults, 
> which can't be removed.  Here's the relevant config:
>
> interface Port-channel1
>  description << TO GI9/5 10/5 >>
>  no ip address
>  no ip redirects
>  random-detect
> !
> interface Port-channel1.11
>  encapsulation dot1Q 11
>  ip address IP 255.255.255.0
>  no ip redirects
>  ip ospf authentication-key 7
>  ip ospf cost 1
>  ip ospf dead-interval minimal hello-multiplier 4
> !
> interface FastEthernet0/0
>  description << TO 9/5 >>
>  no ip address
>  no ip redirects
>  no ip unreachables
>  duplex full
>  random-detect
>  no cdp enable
> !
> interface FastEthernet2/0
>  description << TO 10/5 >>
>  no ip address
>  no ip redirects
>  no ip unreachables
>  duplex full
>  no cdp enable
> !
>
> Any tips/help would be greatly appreciated.
>
> Thanks,
> Jason
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/