[c-nsp] Cisco CISCO7606-S Module

[Arie Vayner (avayner)]

Mohammad,

This could be (after a very quick query) related to CSCef46923 "Group of
4 ports on WS-X6516-xx modules may stop forwarding traffic"

These are the release notes:
PROBLEM/SYMPTOMS
================
Under very rare conditions, a group of ports on the same port-ASIC may
experience connectivity issue. This issue can occur on any module which
uses the same port-ASIC as WS-X6516-GE-TX.

The following syslog messages might also be seen, but is not required to
observe the issue.

%PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 4 is experiencing the following
error:
Pinnacle #0, Frames with Bad Packet CRC Error (PI_CI_S_PKTCRC_ERR -
0xC7) = 
110


Syslog Messages update  (3/14/05)
==========================================

Examples of Syslog message from IOS:
______________________________________________________________
%PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 5 is experiencing the following
error:
PINNACLE Pb transient parity error detected : ports - 1 3 5 7

%PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 5 is experiencing the following
error:
Bus Asic #1 transient Pb error.  Recovered. (0x1234, 0x5678)


Examples of Syslog message from CatOS:
______________________________________________________________
 
%SYS-3-PKTBUFFERFAIL_ERRDIS:Packet buffer failure detected.
Err-disabling 
port 5/5.
 
%SYS-3-PKTBUFFERFAIL_PWRCYCLE:Packet buffer failure detected. Power
cycling
module 5.
 
______________________________________________________________

Condition
=========
The problem usually happens to a group of ports that are connected 
through the same ASIC.
  
WORKAROUND
==========
The problem will usually recover after hard-reset the module.  If the
problem
keeps happening on the same module, please contact TAC.






So, I would suggest you contact TAC for this...
Arie

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Mohammad Khalil
Sent: Sunday, August 22, 2010 10:26
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Cisco CISCO7606-S Module




We
are facing some issues with our Cisco CISCO7606-S on the
module SFM-capable 48 port 10/100/1000mb RJ45 (Model Number
WS-X6548-GE-TX) 
please see the log below:Aug 21 03:53:18.275 EET:
%PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is experiencing the following
error: Bus Asic #0 transient Pb error.  Recovered (0x0000, 0x0042) 
Aug 21 03:53:31.327 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
experiencing the following error: Bus Asic #0 transient Pb error.
Recovered (0x0000, 0x0042) 
Aug 21 03:53:44.579 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
experiencing the following error: Bus Asic #0 transient Pb error.
Recovered (0x0000, 0x0046) 
Aug 21 03:53:57.631 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
experiencing the following error: Bus Asic #0 transient Pb error.
Recovered (0x0000, 0x0042) 
Aug 21 03:54:11.392 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
experiencing the following error: Bus Asic #0 transient Pb error.
Recovered (0x0000, 0x0042)
any ideas ?  

Thanks in advance
Best Regards,



 		 	   		  
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/