[c-nsp] Cisco CISCO7606-S Module
Mohammad Khalil
eng_mssk at hotmail.com
Sat Aug 28 08:51:13 EDT 2010
hi Arie
Hope this
mail finds you well
We have
received the card and replaced the faulty one , but the module is still down
please check the outputs listed below
Show log :
Aug 28
14:00:19.180 EET: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestLoopback
failed on port(s) 1-48
Aug 28
14:00:19.180 EET: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestL3VlanMet
failed
Aug 28
14:00:19.180 EET: %CONST_DIAG-SP-3-BOOTUP_TEST_FAIL: Module 3: TestIngressSpan
failed
Aug 28
14:00:19.252 EET: %OIR-SP-3-LC_FAILURE: Module 3 has Major online diagnostic
failure, Card will be powered down. Please check bootflash diaginfo file for
detailed diagnostic result.
Aug 28
14:00:19.600 EET: %DIAG-SP-6-DIAG_OK: Module 1: Passed Online Diagnostics
Aug 28 14:00:19.732
EET: %C6KPWR-SP-4-DISABLED: power to module in slot 3 set off (Diagnostic
Failure)
Show module
:
CR2.KJ-Building#sh
module 3
Mod Ports
Card
Type
Model
Serial No.
--- -----
-------------------------------------- ------------------ -----------
3 48 SFM-capable 48 port 10/100/1000mb RJ45
WS-X6548-GE-TX SAL104574QA
Mod MAC
addresses
Hw
Fw
Sw Status
---
---------------------------------- ------ ------------ ------------ -------
3 0019.5635.a600 to 0019.5635.a62f 11.1
7.2(1) 8.7(0.22)SRD PwrDown
Mod
Online Diag Status
----
-------------------
3 Not Applicable
Any advice
please
Thanks
Best
Regards,
> Subject: RE: [c-nsp] Cisco CISCO7606-S Module
> Date: Sun, 22 Aug 2010 15:37:16 +0200
> From: avayner at cisco.com
> To: eng_mssk at hotmail.com; cisco-nsp at puck.nether.net
>
> Mohammad,
>
> This could be (after a very quick query) related to CSCef46923 "Group of
> 4 ports on WS-X6516-xx modules may stop forwarding traffic"
>
> These are the release notes:
> PROBLEM/SYMPTOMS
> ================
> Under very rare conditions, a group of ports on the same port-ASIC may
> experience connectivity issue. This issue can occur on any module which
> uses the same port-ASIC as WS-X6516-GE-TX.
>
> The following syslog messages might also be seen, but is not required to
> observe the issue.
>
> %PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 4 is experiencing the following
> error:
> Pinnacle #0, Frames with Bad Packet CRC Error (PI_CI_S_PKTCRC_ERR -
> 0xC7) =
> 110
>
>
> Syslog Messages update (3/14/05)
> ==========================================
>
> Examples of Syslog message from IOS:
> ______________________________________________________________
> %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 5 is experiencing the following
> error:
> PINNACLE Pb transient parity error detected : ports - 1 3 5 7
>
> %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 5 is experiencing the following
> error:
> Bus Asic #1 transient Pb error. Recovered. (0x1234, 0x5678)
>
>
> Examples of Syslog message from CatOS:
> ______________________________________________________________
>
> %SYS-3-PKTBUFFERFAIL_ERRDIS:Packet buffer failure detected.
> Err-disabling
> port 5/5.
>
> %SYS-3-PKTBUFFERFAIL_PWRCYCLE:Packet buffer failure detected. Power
> cycling
> module 5.
>
> ______________________________________________________________
>
> Condition
> =========
> The problem usually happens to a group of ports that are connected
> through the same ASIC.
>
> WORKAROUND
> ==========
> The problem will usually recover after hard-reset the module. If the
> problem
> keeps happening on the same module, please contact TAC.
>
>
>
>
>
>
> So, I would suggest you contact TAC for this...
> Arie
>
> -----Original Message-----
> From: cisco-nsp-bounces at puck.nether.net
> [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Mohammad Khalil
> Sent: Sunday, August 22, 2010 10:26
> To: cisco-nsp at puck.nether.net
> Subject: [c-nsp] Cisco CISCO7606-S Module
>
>
>
>
> We
> are facing some issues with our Cisco CISCO7606-S on the
> module SFM-capable 48 port 10/100/1000mb RJ45 (Model Number
> WS-X6548-GE-TX)
> please see the log below:Aug 21 03:53:18.275 EET:
> %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is experiencing the following
> error: Bus Asic #0 transient Pb error. Recovered (0x0000, 0x0042)
> Aug 21 03:53:31.327 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
> experiencing the following error: Bus Asic #0 transient Pb error.
> Recovered (0x0000, 0x0042)
> Aug 21 03:53:44.579 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
> experiencing the following error: Bus Asic #0 transient Pb error.
> Recovered (0x0000, 0x0046)
> Aug 21 03:53:57.631 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
> experiencing the following error: Bus Asic #0 transient Pb error.
> Recovered (0x0000, 0x0042)
> Aug 21 03:54:11.392 EET: %PM_SCP-SP-2-LCP_FW_ERR_INFORM: Module 3 is
> experiencing the following error: Bus Asic #0 transient Pb error.
> Recovered (0x0000, 0x0042)
> any ideas ?
>
> Thanks in advance
> Best Regards,
>
>
>
>
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
More information about the cisco-nsp
mailing list