[c-nsp] EOMPLS between 10G subinterface and GE subinterface between two 7600

[Ioan Branet]

Hello,

We run EOMPLS on port and vlan mode on GE interfaces but we did not run
EOMPLS Vlan mode between 10G and 1G subinterfaces until now.

Any feedback is appreciated.
Thank you,
John

On Wed, Feb 17, 2010 at 10:43 AM, Mikael Abrahamsson <swmike at swm.pp.se>wrote:

> On Wed, 17 Feb 2010, Ioan Branet wrote:
>
> You should answer to the list, answering just to me doesn't make much
> sense.
>
> SRB4 is buggy, stop running it. Try latest SRB (SRB6 or 7, I don't
> remember), or go SRD3 or later.
>
>
>  Hello,
>>
>> We are running on both PEs the following:
>> sh ver | i IOS
>> Cisco IOS Software, c7600s72033_rp Software
>> (c7600s72033_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRB4, RELEASE SOFTWARE
>> (fc3)
>>
>> 10G card on PE1 is:
>> show module 7
>> Mod Ports Card Type                              Model              Serial
>> No.
>> --- ----- -------------------------------------- ------------------
>> -----------
>>  7    4  CEF720 4 port 10-Gigabit Ethernet      WS-X6704-10GE
>> SAL1337YN4W
>>
>> and 1G on PE2 is:
>>
>>
>> ro-sv01a-rd2#show module 2
>> Mod Ports Card Type                              Model              Serial
>> No.
>> --- ----- -------------------------------------- ------------------
>> -----------
>>  2   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP
>> SAL1005CBXG
>>
>> Mod MAC addresses                       Hw    Fw           Sw
>> Status
>> --- ---------------------------------- ------ ------------ ------------
>> -------
>>  2  0016.c8c4.fc10 to 0016.c8c4.fc27   2.3   12.2(14r)S5  12.2(33)SRB4 Ok
>>
>> Mod  Sub-Module                  Model              Serial       Hw
>> Status
>> ---- --------------------------- ------------------ ----------- -------
>> -------
>>  2  Centralized Forwarding Card WS-F6700-CFC       SAL1014J60S  2.0    Ok
>>
>> Mod  Online Diag Status
>> ---- -------------------
>>  2  Pass
>>
>> Thank you,
>> John
>>
>> On Wed, Feb 17, 2010 at 10:27 AM, Mikael Abrahamsson <swmike at swm.pp.se
>> >wrote:
>>
>>  On Wed, 17 Feb 2010, Ioan Branet wrote:
>>>
>>>  GE interface between two 7600 as PE.
>>>
>>>>
>>>>
>>> You forgot to include what software you're running.
>>>
>>> --
>>> Mikael Abrahamsson    email: swmike at swm.pp.se
>>>
>>>
>>
> --
> Mikael Abrahamsson    email: swmike at swm.pp.se
>