[c-nsp] EOMPLS between 10G subinterface and GE subinterface between two 7600
Ioan Branet
ioan.branet at gmail.com
Fri Feb 19 07:26:31 EST 2010
Hello,
I do not have x-connect interface attached as I can see:
#show MPLS platform EoMPLS | include 7/3
#
If I create an EOMPLS on a 6500 with 10G interface connected to the same
Juniper it works ,i can ping between CE1 and CE2 so the problem seemd to be
on the 7600.
Thank you,
John
On Thu, Feb 18, 2010 at 10:09 PM, Manu Chao <linux.yahoo at gmail.com> wrote:
> switchport nonegociate missing on the pe?
>
> 2010/2/17, Ioan Branet <ioan.branet at gmail.com>:
> > Hello,
> >
> > I used also vlan-tagging but with same result:
> >
> > show configuration interfaces xe-3/1/0
> > description "** Link To PE1 **";
> > vlan-tagging;
> > link-mode full-duplex;
> > gigether-options {
> > no-auto-negotiation;
> > }
> > unit 999 {
> > bandwidth 10g;
> > vlan-id 999;
> > family inet {
> > accounting {
> > source-class-usage {
> > input;
> > }
> > }
> > no-redirects;
> > sampling {
> > input;
> > }
> > address 150.1.1.2/30 {
> > primary;
> > preferred;
> > }
> > }
> > }
> >
> > #ping 150.1.1.2
> >
> > Type escape sequence to abort.
> > Sending 5, 100-byte ICMP Echos to 150.1.1.2, timeout is 2 seconds:
> > .....
> > Success rate is 0 percent (0/5)
> >
> > On Wed, Feb 17, 2010 at 7:06 PM, Manu Chao <linux.yahoo at gmail.com>
> wrote:
> >
> >> Hello,
> >>
> >> It is just a config problem on your J CE1: You needn't
> >> flexible-vlan-tagging (nor flexible-ethernet-services encapsulation)
> >>
> >> R/
> >> Manu
> >> On Wed, Feb 17, 2010 at 5:01 PM, Ioan Branet <ioan.branet at gmail.com
> >wrote:
> >>
> >>> Hello,
> >>>
> >>> I tried with Cisco 7600 as CE instead of Juniper and it works, I have
> to
> >>> find out what is wrong there.
> >>>
> >>> Thank you for your help,
> >>> Regards,
> >>> John
> >>>
> >>> ---------- Forwarded message ----------
> >>> From: Ioan Branet <ioan.branet at gmail.com>
> >>> Date: Wed, Feb 17, 2010 at 11:44 AM
> >>> Subject: Re: [c-nsp] EOMPLS between 10G subinterface and GE
> subinterface
> >>> between two 7600
> >>> To: Tassos Chatzithomaoglou <achatz at forthnet.gr>
> >>> Cc: cisco-nsp at puck.nether.net
> >>>
> >>>
> >>> Hello,
> >>>
> >>> Maybe there is a bug with SRB IOS.
> >>> I still have VC up on both ends but I cant ping between CE1 and CE2.
> >>>
> >>> On CE1 (Juniper side) I learn arp address of remote CE2 device and
> >>> receive
> >>> arp request and send arp reply:
> >>>
> >>>
> >>> show arp no-resolve | match xe-3/1/0
> >>> 00:16:9c:6d:42:80 150.1.1.1 xe-3/1/0.999 none
> >>>
> >>>
> >>> Juniper PCAP Flags [Ext, In], PCAP Extension(s) total length 22
> >>> Device Media Type Extension TLV #3, length 1, value: Ethernet
> >>> (1)
> >>> Logical Interface Encapsulation Extension TLV #6, length 1,
> >>> value:
> >>> Ethernet (14)
> >>> Device Interface Index Extension TLV #1, length 2, value: 193
> >>> Logical Interface Index Extension TLV #4, length 4, value: 126
> >>> Logical Unit Number Extension TLV #5, length 4, value: 32767
> >>> -----original packet-----
> >>> 0:16:9c:6d:42:80 > Broadcast, ethertype 802.1Q (0x8100), length
> >>> 64:
> >>> vlan 999, p 0, ethertype ARP, arp who-has 150.1.1.2 tell 150.1.1.1
> >>> 11:34:01.878596 Out
> >>> Juniper PCAP Flags [Ext], PCAP Extension(s) total length 22
> >>> Device Media Type Extension TLV #3, length 1, value: Ethernet
> >>> (1)
> >>> Logical Interface Encapsulation Extension TLV #6, length 1,
> >>> value:
> >>> Ethernet (14)
> >>> Device Interface Index Extension TLV #1, length 2, value: 193
> >>> Logical Interface Index Extension TLV #4, length 4, value: 126
> >>> Logical Unit Number Extension TLV #5, length 4, value: 32767
> >>> -----original packet-----
> >>> 0:21:59:a7:c4:30 > 0:16:9c:6d:42:80, ethertype 802.1Q (0x8100),
> >>> length 46: vlan 999, p 0, ethertype ARP, arp reply 150.1.1.2 is-at
> >>> 0:21:59:a7:c4:30.
> >>>
> >>> The issue is that I can't upgrade to SRD IOS.
> >>>
> >>> thank you,
> >>> John
> >>>
> >>>
> >>>
> >>> On Wed, Feb 17, 2010 at 11:05 AM, Tassos Chatzithomaoglou <
> >>> achatz at forthnet.gr> wrote:
> >>>
> >>> > I'm running EoMPLS between 10GE subif and 1GE subif without any
> >>> > problem.
> >>> >
> >>> > 7600-a>sh mpls l2 vc 3601
> >>> >
> >>> > Local intf Local circuit Dest address VC ID
> >>> Status
> >>> > ------------- -------------------------- --------------- ----------
> >>> > ----------
> >>> > Gi4/20.3601 Eth VLAN 3601 x.x.x.x 3601
> UP
> >>> >
> >>> >
> >>> > 7600-b>sh mpls l2 vc 3601
> >>> >
> >>> > Local intf Local circuit Dest address VC ID
> >>> Status
> >>> > ------------- -------------------------- --------------- ----------
> >>> > ----------
> >>> > Te3/2.3601 Eth VLAN 3601 x.x.x.x 3601
> UP
> >>> >
> >>> >
> >>> > Both 7600s are running SRD3.
> >>> >
> >>> > --
> >>> > Tassos
> >>> >
> >>> > Ioan Branet wrote on 17/02/2010 10:49:
> >>> >
> >>> >> Hello,
> >>> >>
> >>> >> We run EOMPLS on port and vlan mode on GE interfaces but we did not
> >>> >> run
> >>> >> EOMPLS Vlan mode between 10G and 1G subinterfaces until now.
> >>> >>
> >>> >> Any feedback is appreciated.
> >>> >> Thank you,
> >>> >> John
> >>> >>
> >>> >> On Wed, Feb 17, 2010 at 10:43 AM, Mikael Abrahamsson <
> swmike at swm.pp.se
> >>> >> >wrote:
> >>> >>
> >>> >>
> >>> >>
> >>> >>> On Wed, 17 Feb 2010, Ioan Branet wrote:
> >>> >>>
> >>> >>> You should answer to the list, answering just to me doesn't make
> much
> >>> >>> sense.
> >>> >>>
> >>> >>> SRB4 is buggy, stop running it. Try latest SRB (SRB6 or 7, I don't
> >>> >>> remember), or go SRD3 or later.
> >>> >>>
> >>> >>>
> >>> >>> Hello,
> >>> >>>
> >>> >>>
> >>> >>>> We are running on both PEs the following:
> >>> >>>> sh ver | i IOS
> >>> >>>> Cisco IOS Software, c7600s72033_rp Software
> >>> >>>> (c7600s72033_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRB4, RELEASE
> >>> >>>> SOFTWARE
> >>> >>>> (fc3)
> >>> >>>>
> >>> >>>> 10G card on PE1 is:
> >>> >>>> show module 7
> >>> >>>> Mod Ports Card Type Model
> >>> >>>> Serial
> >>> >>>> No.
> >>> >>>> --- ----- --------------------------------------
> ------------------
> >>> >>>> -----------
> >>> >>>> 7 4 CEF720 4 port 10-Gigabit Ethernet WS-X6704-10GE
> >>> >>>> SAL1337YN4W
> >>> >>>>
> >>> >>>> and 1G on PE2 is:
> >>> >>>>
> >>> >>>>
> >>> >>>> ro-sv01a-rd2#show module 2
> >>> >>>> Mod Ports Card Type Model
> >>> >>>> Serial
> >>> >>>> No.
> >>> >>>> --- ----- --------------------------------------
> ------------------
> >>> >>>> -----------
> >>> >>>> 2 24 CEF720 24 port 1000mb SFP WS-X6724-SFP
> >>> >>>> SAL1005CBXG
> >>> >>>>
> >>> >>>> Mod MAC addresses Hw Fw Sw
> >>> >>>> Status
> >>> >>>> --- ---------------------------------- ------ ------------
> >>> ------------
> >>> >>>> -------
> >>> >>>> 2 0016.c8c4.fc10 to 0016.c8c4.fc27 2.3 12.2(14r)S5
> >>> 12.2(33)SRB4
> >>> >>>> Ok
> >>> >>>>
> >>> >>>> Mod Sub-Module Model Serial
> Hw
> >>> >>>> Status
> >>> >>>> ---- --------------------------- ------------------ -----------
> >>> -------
> >>> >>>> -------
> >>> >>>> 2 Centralized Forwarding Card WS-F6700-CFC SAL1014J60S
> 2.0
> >>> >>>> Ok
> >>> >>>>
> >>> >>>> Mod Online Diag Status
> >>> >>>> ---- -------------------
> >>> >>>> 2 Pass
> >>> >>>>
> >>> >>>> Thank you,
> >>> >>>> John
> >>> >>>>
> >>> >>>> On Wed, Feb 17, 2010 at 10:27 AM, Mikael Abrahamsson <
> >>> swmike at swm.pp.se
> >>> >>>>
> >>> >>>>
> >>> >>>>> wrote:
> >>> >>>>>
> >>> >>>>>
> >>> >>>> On Wed, 17 Feb 2010, Ioan Branet wrote:
> >>> >>>>
> >>> >>>>
> >>> >>>>> GE interface between two 7600 as PE.
> >>> >>>>>
> >>> >>>>>
> >>> >>>>>
> >>> >>>>>>
> >>> >>>>>>
> >>> >>>>> You forgot to include what software you're running.
> >>> >>>>>
> >>> >>>>> --
> >>> >>>>> Mikael Abrahamsson email: swmike at swm.pp.se
> >>> >>>>>
> >>> >>>>>
> >>> >>>>>
> >>> >>>>>
> >>> >>>> --
> >>> >>> Mikael Abrahamsson email: swmike at swm.pp.se
> >>> >>>
> >>> >>>
> >>> >>>
> >>> >> _______________________________________________
> >>> >> cisco-nsp mailing list cisco-nsp at puck.nether.net
> >>> >> https://puck.nether.net/mailman/listinfo/cisco-nsp
> >>> >> archive at http://puck.nether.net/pipermail/cisco-nsp/
> >>> >>
> >>> >>
> >>> >>
> >>> >
> >>> > _______________________________________________
> >>> > cisco-nsp mailing list cisco-nsp at puck.nether.net
> >>> > https://puck.nether.net/mailman/listinfo/cisco-nsp
> >>> > archive at http://puck.nether.net/pipermail/cisco-nsp/
> >>> >
> >>> _______________________________________________
> >>> cisco-nsp mailing list cisco-nsp at puck.nether.net
> >>> https://puck.nether.net/mailman/listinfo/cisco-nsp
> >>> archive at http://puck.nether.net/pipermail/cisco-nsp/
> >>>
> >>
> >>
> >
> >
> > --
>
More information about the cisco-nsp
mailing list