[c-nsp] cisco 2801 and HWIC-2T

[Per Carlson]

On Mon, Jan 18, 2010 at 16:39, Ryan West <rwest at zyedge.com> wrote:
> The card is supported on your platform, but it's a T1 only card, so controller e1 or card type won't work for it.

No it's not. All "T" (H)WICs are for serial interfaces, which is *not*
the same as a T1/E1. To use this type of (H)WIC you need a serialized
interface from your leased line provider and a suitable cable. The
connector types commonly used on serial interaces are V.35 and X.21.

BTW, on serial interfaces there are no "controller e1" stanzas, see
http://www.cisco.com/en/US/docs/ios/interface/configuration/guide/ir_cfg_ser_if_ps10591_TSD_Products_Configuration_Guide_Chapter.html#wp1012694

-- 
Pelle