[c-nsp] 6PE: was: mpls over native ipv6?

[Mateusz Blaszczyk]

On 30 June 2010 02:57, Harold Ritter <hritter at cisco.com> wrote:
> Hi Christian,
>
> Most recent IOS versions should support 6PE. The command "mpls ipv6 source-interface" has been removed from most recent IOS versions as well. This command only applied to locally originated traffic and the source address selection is now as per RFC3484.
>

And what IPv6 address should it be used by 6PE router when originating
ICMPv6 packets in response to traceroutes coming from behind the MPLS
network?
On 7600 with SRB7[1] and SRD[2] it takes an IPv6 address that is
configured on the first physical interface (ie. not SVI) visible in
the configuration...
Not like with MPLS/VPNs where the source address is taken from the
egress interface towards VPN.

Bug?

Best Regards,

-mat

[1] Cisco IOS Software, c7600rsp72043_rp Software
(c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRB7, RELEASE
SOFTWARE (fc1)
[2] Cisco IOS Software, c7600rsp72043_rp Software
(c7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD, RELEASE
SOFTWARE (fc2)