[c-nsp] mpls + ipv4 route

[Łukasz Bromirski]

On 2010-05-01 18:10, Matteo Abrile wrote:

> We have bit confusion because when we use cisco 6500 with mpls + bgp
 > and ospf, if we check tcam we found so:

MPLS by default will assign label to every prefix learned via IGP.
Given 226k prefixes were assigned labels, I'd look into configs
right away.

>  detail:      Protocol                    Used       %Used
>               IPv4                      292787         56%
>               MPLS                      226050         43%
>               EoM                            1          1%
>
> I would have BGP and OSPF only in IPv4 partition of TCAM, how to do
 > it ??

You can easily go for 'mls cef maximum-routes ip 1007' given that
You have XL card, and reload the box, but this will only hide problem,
not solve it.

For some reason BGP is leaking prefixes to IGP, or there's some problem
with the IGP deployment itself.

Can you show us output of 'sh ip route summary' and the config snippets
of both any IGP configured on the box and BGP without neighbor-specific
settings? I'd say anything with 'mpls' will also be useful.

-- 
"Everything will be okay in the end.  |                 Łukasz Bromirski
  If it's not okay, it's not the end." |      http://lukasz.bromirski.net