[c-nsp] Static MPLS labels/tunnels

[Tassos Chatzithomaoglou]

"mpls static binding ipv4" should give you a start. You have to define some label ranges first.

--
Tassos


Phil Mayers wrote on 20/11/2010 14:43:
> Quick question - this is for my curiosity rather than anything, as 
> I've never done this before.
>
> We have a few RAD IP-Mux boxes (E1->IP). They claim to support MPLS, 
> and allow you to specify an outgoing and incoming MPLS label for a 
> circuit. They don't seem to support any dynamic protocol e.g. LDP, BGP 
> or so forth.
>
> Not that I want to, but: how would one configure the interfaces on a 
> 6500/sup720? That is, give the network:
>
> mux1 == 6500-1 == (cloud of P-routers) == 6500-2 == mux1
>
> ...what do I type in on 6500-1 and 6500-2 to configure an LSP and bind 
> a fixed label mapping into and out of that LSP?
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>