[c-nsp] FRU-power failed help me

[Brian Fitzgerald]

Seen this - in our case it was the on-card power regulator that died.

6500 uses a single DC voltage (42V) in the backplane, and has voltage
regulators on the cards.  Regulator dies, and you lose the card.

You probably have a dead card.  Time to call TAC/sub in spare/hunt down
replacement.


Brian Fitzgerald
Sr. Network & Security Admin.
ITS, Camosun College, Victoria, BC.







On 10-11-25 6:57 AM, "Bayasgalan Bayantur" <mnblogs at gmail.com> wrote:

> Hello Guys,



Can anybody please help me to understand the below error is
> related to
Power/Chassis/Module ?




%OIR-SP-6-PWRFAILURE: Module 3 is being
> disabled due to power convertor
failure
%C6KPWR-SP-4-DISABLED: power to module
> in slot 3 set off (FRU-power failed)

6513-SW2#hw-module module 3
> reset
Proceed with reload of module?[confirm]
% module 3 is operationally off
> (FRU-power failed)



00:01:20: %C6KENV-SP-4-FANHIOUTPUT: Version 2
> high-output fan-tray is in
effect
00:01:28: %OIR-SP-6-PWRFAILURE: Module 3 is
> being disabled due to power
convertor failure
00:01:28: %C6KPWR-SP-4-DISABLED:
> power to module in slot 3 set off
(FRU-power failed)


--
> 
***********************
Таныг хүндэтгэсэн

> Б.Баясгалан
***********************
__________________________________________
> _____
cisco-nsp mailing list
> cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
a
> rchive at http://puck.nether.net/pipermail/cisco-nsp/