[c-nsp] Cisco ASA 5510 Failover- Active/StandBy

[danger will]

Yes i remember you need a certain license to be able to do failover . 
You could just try to configure it and if you don;t have the proper 
license it should say something about that , or just contact your cisco 
reseller 

--- On Sun, 9/12/10, Fourpros it <fourprosit at gmail.com> wrote:

From: Fourpros it <fourprosit at gmail.com>
Subject: [c-nsp] Cisco ASA 5510 Failover- Active/StandBy
To: cisco-nsp at puck.nether.net
Date: Sunday, September 12, 2010, 2:57 PM

Dear experts,
I have  two Cisco ASA 5510, Model ASA5510-AIP10-K9 and ASA5510-CSC10-K9, now
the scenario is to do failover Active/Standby statefull.

On the Model Comparison Sheet of CISCO ASA5500 Series, mentioned that For
Failover on ASA 5510 required a Security Plus licenses and On Cisco ASA
Command Configuration Guide there mentioned Base licenses work required
Security Plus license for ASA 5505 only.
So in my case is it required to have Security Plus license or not???

Another for failover, both device should be identical but i have two
different model device- AIP and CSC. So for this if i remove the module AIP
and CSC from the devices will it be working for failover on normal base
firewall mode ASA.If there is any other method to fulfill this scenario then
please suggest me. Please provide any such procedure that made my Cisco ASA
5510 be used on fail over mode. It will be great help from the experts like
you.

Thank You

Regards,
Fourprosit
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/