[c-nsp] Cisco 6k no power enable module

[Mark Mason]

We also just labbed a VS-S720-10G running 122-33.SXJ1 and were able to shut a slot down without a module installed. Unfortunately we ALSO were able to incorrectly install a WS-X6748-GE-TX and cause the 3 second bus disruption. Anyone else run into this?

6509-v-e-test(config)#no power enable module 6
%FRU Absent. Power admin state updated
6509-v-e-test(config)#no power enable module 6
% slot is already disabled and not yet enabled
6509-v-e-test(config)#no power enable module 7
%FRU Absent. Power admin state updated
6509-v-e-test(config)#no power enable module 7
% slot is already disabled and not yet enabled
6509-v-e-test(config)#no power enable module 8
%FRU Absent. Power admin state updated
6509-v-e-test(config)#no power enable module 8
% slot is already disabled and not yet enabled
6509-v-e-test(config)#no power enable module 9
%FRU Absent. Power admin state updated
6509-v-e-test(config)#
6509-v-e-test(config)#no power enable module 9
% slot is already disabled and not yet enabled
6509-v-e-test(config)#
*Dec  1 21:14:36.304: %C6KPWR-SP-4-DISABLED: power to module in slot 8 set off (admin request)
6509-v-e-test(config)#
*Dec  1 21:15:07.123: %OIR-SP-6-REMCARD: Card removed from slot 8, interfaces disabled
*Dec  1 21:15:11.027: %C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is experiencing stall for 3 seconds
*Dec  1 21:15:16.063: %C6KERRDETECT-SP-2-SWBUSSTALL_RECOVERED: The switching bus stall is recovered and data traffic switching continues
*Dec  1 21:15:18.283: %C6KPWR-SP-4-DISABLED: power to module in slot 8 set off (admin request)


Mark

From: Mark Mason
Sent: Thursday, December 01, 2011 2:38 PM
To: 'cisco-nsp at puck.nether.net'
Subject: Cisco 6k no power enable module

Anyone know why Cisco doesn't allow for you to shut power down to a slot/module unless a FRU is installed in it? We can reproduce 100% multiple times in the lab WS-X6748-GE-TX installation's that causes the bus to stall 3 seconds. It has to do with the force you apply to the card during installation.

%C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is experiencing stall for 3 seconds
%C6KERRDETECT-SP-2-SWBUSSTALL_RECOVERED: The switching bus stall is recovered and data traffic switching continues


Router(config)#no power enable module 8
%FRU Absent. Power admin state updated


Mark

NOTICE: This electronic mail message and any files transmitted with it are intended
exclusively for the individual or entity to which it is addressed. The message, 
together with any attachment, may contain confidential and/or privileged information.
Any unauthorized review, use, printing, saving, copying, disclosure or distribution 
is strictly prohibited. If you have received this message in error, please 
immediately advise the sender by reply email and delete all copies.