[c-nsp] OER Question

[M K]

Hi all , Bruce i am asking on the best Cisco forum , is that wrong ????

> Date: Wed, 7 Dec 2011 03:07:22 +0100
> From: robert at raszuk.net
> To: bep at whack.org
> CC: gunner_200 at live.com; cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] OER Question
> 
> Bruce,
> 
>  > you are fishing for an answer.
> 
> And what's wrong with that ???
> 
> Cheers,
> R.
> 
> 
> > M K wrote:
> >>
> >> Hi all,
> >>
> >> i have the below OER question
> >> i have been trying since a while but i am not sure about the solution
> >> can anyone please help ?
> >> Configure R4 to be the master controller and R1 and R2 to be the
> >> Border routers.
> >> The OER implementation should be optimized such that when the
> >> packets with a DSCP of 41 is passing through the network, it is routed
> >> out to
> >> R1 exit interface and also, when a DSCP of 31 is passing through, it
> >> is routed
> >> out to R2 exit interface.
> >> You are allowed to create extended ACL with one entry to accomplish
> >> this task.
> >> Set active probes only
> >> For traffic going from Vlan 44 to YY.YY.55.5, set jitter as 40, delay
> >> as 20, probe frequency as 2.
> >> Enable constant probe via all exit interfaces.
> >>
> >> R5 -- SW2 -- SW1 -- R1 F0/0
> >> R1 S0/0 -- R4 S0/0 , R4 S0/1 -- R2 S0/0
> >> R2 F0/0 -- SW4 -- SW3
> >> all the switches are trunk interconnected
> >>
> >
> > The wording on this question sounds suspiciously like a Cisco
> > certification question and that you are fishing for an answer.
> >
>