[c-nsp] CISCO 1841

[Nikolay Shopik]

You are having faulty patch-cord, replace it and you should be fine.

On 08/12/11 14:01, Wakwa Nduati wrote:
> On the main device I get on both interfaces
>
> f0/0 136 unknown protocol drops
> f0/1 31 unknown protocol drops
>
> On the connecting switch
>
>   Input:  1350 input errors, 0 runts, 0 giants,  - throttles, 1153 CRC
>           - frame,  - overruns, 197 aborts, - ignored, - parity errors
>
> and
>
> Input:  43301 input errors, 0 runts, 0 giants,  - throttles, 41151 CRC
>           - frame,  - overruns, 2150 aborts, - ignored, - parity errors
>
> Thanks
>
>
> On Thu, Dec 8, 2011 at 12:46 PM, David Rothera<david.rothera at gmail.com>wrote:
>
>> I take it you also have the associated down messages as well? If you are
>> having interface drops then I would look into that rather than just
>> ignoring it.
>>
>> Do you get drops on the device that is on the other end of these
>> connections?
>>
>> David Rothera
>>
>>
>>
>> On Thu, Dec 8, 2011 at 9:17 AM, Wakwa Nduati<wnwakwan at gmail.com>  wrote:
>>
>>> Hi,
>>>
>>> I have a cisco 1841 on my network and though working ok has this messages.
>>>
>>> It is connected to a gigabit switch and the ports set to 100Mbps.
>>>
>>> What would this mean and how do I clear them?
>>>
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>> : %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
>>>
>>> Config
>>>
>>> global - ip cef is enabled
>>>
>>> interface FastEthernet0/0
>>>   ip address x.x.x.x y.y.y.y
>>>   ip ospf message-digest-key zzzzzzzzzzzz
>>>   ip ospf priority 0
>>>   duplex auto
>>>   speed auto
>>>   no cdp enable
>>>   max-reserved-bandwidth 100
>>> !
>>> interface FastEthernet0/1 (connected and supporting dot1q interfaces)
>>>   no ip address
>>>   duplex auto
>>>   speed auto
>>>
>>> Thanks.
>>> _______________________________________________
>>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>>>
>>
>>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/