[c-nsp] How to see interface configuration after card failure on ASR9K

Jason Lixfeld jason at lixfeld.ca
Tue Dec 27 13:38:58 EST 2011

You are right!  My mistake.


Sent from my mobile device

On 2011-12-27, at 1:31 PM, Mark Tinka <mtinka at globaltransit.net> wrote:

> On Wednesday, December 28, 2011 02:19:24 AM Jason Lixfeld 
> wrote:
>> Show config rollback last X (or some variant of that)
>> should show you what you want to see.
> 'sh configuration rollback changes last' to be exact.
> But that will only show the OP changes that were applied to 
> a running configuration.
> I think what the OP is looking for is, basically, a version 
> of the total configuration prior to a line card being pulled 
> out. 
> To increase your chances of finding this, John, I'll suggest 
> checking the high-numbered commits, e.g., 90, 91, e.t.c., or 
> the commits that correspond to when the line card was first 
> installed into the router.
> Mark.

More information about the cisco-nsp mailing list