[c-nsp] How to see interface configuration after card failure on ASR9K

[Vitkovsky, Adam]

Pre-configuration is possible with XR as well

adam

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Daniel Roesen
Sent: Wednesday, December 28, 2011 1:15 PM
To: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] How to see interface configuration after card failure on ASR9K

On Wed, Dec 28, 2011 at 10:31:31AM +0800, Mark Tinka wrote:
> On Wednesday, December 28, 2011 03:13:35 AM John Neiberger 
> wrote:
> 
> > I thought for sure there was a command that would show
> > the preconfigured interfaces. As soon as I insert the
> > new card, the preexisting configuration will magically
> > appear again.
> 
> That is the Juniper way :-).

No, with JUNOS adding/removing hardware won't change the config at all.
You can preconfigure interfaces that were never installed in the chassis
before, and config remains present when shutting down or even removing
interfaces.

Looks like IOS-XR still has a long way to go to become as usable as
JUNOS in "configuration" matters.

Best regards,
Daniel

-- 
CLUE-RIPE -- Jabber: dr at cluenet.de -- dr at IRCnet -- PGP: 0xA85C8AA0
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/