[c-nsp] MAC address problem with Cat3550
Tóth András
diosbejgli at gmail.com
Mon Feb 28 16:42:12 EST 2011
Hi,
It is caused by an older type of PHY being used on a limited number of
switches only. Newer versions of the 3550 are not causing this
problem.
Best regards,
Andras
On Mon, Feb 28, 2011 at 1:35 AM, daigo nakayama <nkymdg at gmail.com> wrote:
> Hi,
>
> I found one problem with Catalyst3550.
> It has already turned out that the cause of the problem is Bug CSCdx74914.
>
> Vender's engineer said that
>
> - Only frames with destination MAC address 5xxx-xxxx-xxxx
> - Only received on 10Mb/sec interfaces
> - The FCS errors counter increments
> - Work around is 'Reconfigure the interface to operate at 100Mb/sec'
>
> Why does this problem occur only by 10Mbps?
> What is different in 100Mbps and 10Mbps? (100BASE-TX and 10BASE-T??)
> Does anyone know the generating mechanism of this behavior?
>
> I worry that the same behavior by not only 5xxx but also other numbers.
>
> Regards,
>
> -----
> nkymdg
> _______________________________________________
> cisco-nsp mailing list cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
More information about the cisco-nsp
mailing list