[c-nsp] 3560E TCAM Question

[Robert Maier]

so,,the routes clear now...bu when i make a sh plat tcam util on a 2960 
it says alsways that tehere are 27/27 acl used...but there are no acls 
configured/applied, I can´t find a good explaination for the output in 
any command reference.
The only thing which i fond in all reference is something: Don´t use 
that command, except Cisco TAC told you so.

Am 20.01.2011 19:07, schrieb Jose Madrid:
> I have a 3560 and when do I "show platform tcam utilization" it says that I
> have 1365 directly connected routes.  This is definitely not the case and
> when I do a "show ip route connected" there are various IP blocks shown, but
> none longer than a /26 and maybe a total of 30 routes.  Anyone know how
> these numbers are computed?
>
> #sh platform tcam utilization
>
> CAM Utilization for ASIC# 0                      Max            Used
>                                               Masks/Values    Masks/values
>   IPv4 unicast directly-connected routes:      2048/2048       1365/1365
>   IPv4 unicast indirectly-connected routes:    1024/1024        190/190
>