[c-nsp] 3560E TCAM Question

[Tóth András]

Those are used by internal entries, used for certain functions.
Usually there's a permit ip any any entry as well. Also, some entries
are prepopulated. This is normal and expected on DSBU switches.

Best regards,
Andras

On Fri, Jan 21, 2011 at 3:20 PM, Robert Maier <desolationrob at gmail.com> wrote:
> so,,the routes clear now...bu when i make a sh plat tcam util on a 2960 it
> says alsways that tehere are 27/27 acl used...but there are no acls
> configured/applied, I can´t find a good explaination for the output in any
> command reference.
> The only thing which i fond in all reference is something: Don´t use that
> command, except Cisco TAC told you so.
>
> Am 20.01.2011 19:07, schrieb Jose Madrid:
>>
>> I have a 3560 and when do I "show platform tcam utilization" it says that
>> I
>> have 1365 directly connected routes.  This is definitely not the case and
>> when I do a "show ip route connected" there are various IP blocks shown,
>> but
>> none longer than a /26 and maybe a total of 30 routes.  Anyone know how
>> these numbers are computed?
>>
>> #sh platform tcam utilization
>>
>> CAM Utilization for ASIC# 0                      Max            Used
>>                                              Masks/Values    Masks/values
>>  IPv4 unicast directly-connected routes:      2048/2048       1365/1365
>>  IPv4 unicast indirectly-connected routes:    1024/1024        190/190
>>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>