[c-nsp] loss of mgmt vlan interface on 2950g help!

[Mark]

Try getting someone to power cycle the switch. I'm presuming that you have written your previous config to flash.

Mark

On 28-Jan-2011, at 9:15 AM, Mike wrote:

> 
>   I was doing some troubleshooting on my 2950g switch. The 'management interface', is vlan1, and had an ip address and so forth in it I could reach. Apparently, a stupid move was to go into config mode and type the following
> 
> interface vlan 300
> 
>   At that point, my telnet management session went away and the switch is no longer reachable via management any longer, although otherwise continues to function. I am sort of at a loss to understand what the problem is but would love to know so a) I don't do it again and b) to know if there's a way to recover from remote since it's (naturally!) in a very difficult to acccess location, and having management access again would be helpful.
> 
> Thanks.
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/