[c-nsp] WS-X6548-GE-TX Error?

[Chris Knipe]

Hi All,

I have a 6506 and recently installed an WS-X6548-GE-TX into the chassis.
The chassis has already rebooted once, and now I am getting errors too from
the module:

Jun  6 17:11:36 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring
online because of timer event
Jun  6 17:11:36 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set
off (Reset)
Jun  6 17:11:56 SAST: %C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is
experiencing stall for 3 seconds
Jun  6 17:12:45 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring
online because of timer event
Jun  6 17:12:45 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set
off (Reset)
Jun  6 17:12:45 SAST: %C6KERRDETECT-SP-2-SWBUSSTALL_RECOVERED: The switching
bus stall is recovered and data traffic switching continues
Jun  6 17:13:38 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring
online because of timer event
Jun  6 17:13:38 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set
off (Reset)
Jun  6 17:13:38 SAST: SP: oir_disable_notice: slot2: lcp failed to go online

After executing an ‘power enable module 2’, the module does come back online
as indicated below, and all ports available / usable:

Jun  6 19:26:57 SAST: %DIAG-SP-6-RUN_MINIMUM: Module 2: Running Minimum
Online Diagnostics...
Jun  6 19:27:10 SAST: %DIAG-SP-6-DIAG_OK: Module 2: Passed Online
Diagnostics
Jun  6 19:27:10 SAST: %OIR-SP-6-INSCARD: Card inserted in slot 2, interfaces
are now online

The 6506 is running IOS sup22-jk2sv-mx.121-26.E5


Software bug, or faulty hardware ?? 

Kind Regards,
Chris.