[c-nsp] WS-X6548-GE-TX Error?

[Mack McBride]

Is the 6548 card the card in slot 2?
I am assuming it is.

The card either has a bus issue or is not seated properly.
I would try removing the card, check for damage to the connectors, and reseat the card.
You may need to do this with the card in slot 2 and any other cards that have been recently added or worked on.
If reseating the cards doesn't solve the problem, it probably indicates either the module in slot 2 or the recently added card has an issue.  It could also be one of the chassis slots but the card is a more likely culprit.

Mack

-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of Chris Knipe
Sent: Monday, June 06, 2011 11:38 AM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] WS-X6548-GE-TX Error?

Hi All,

I have a 6506 and recently installed an WS-X6548-GE-TX into the chassis.
The chassis has already rebooted once, and now I am getting errors too from
the module:

Jun  6 17:11:36 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring
online because of timer event
Jun  6 17:11:36 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set
off (Reset)
Jun  6 17:11:56 SAST: %C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is
experiencing stall for 3 seconds
Jun  6 17:12:45 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring
online because of timer event
Jun  6 17:12:45 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set
off (Reset)
Jun  6 17:12:45 SAST: %C6KERRDETECT-SP-2-SWBUSSTALL_RECOVERED: The switching
bus stall is recovered and data traffic switching continues
Jun  6 17:13:38 SAST: %ONLINE-SP-6-TIMER: Module 2, Proc. 0. Failed to bring
online because of timer event
Jun  6 17:13:38 SAST: %C6KPWR-SP-4-DISABLED: power to module in slot 2 set
off (Reset)
Jun  6 17:13:38 SAST: SP: oir_disable_notice: slot2: lcp failed to go online

After executing an 'power enable module 2', the module does come back online
as indicated below, and all ports available / usable:

Jun  6 19:26:57 SAST: %DIAG-SP-6-RUN_MINIMUM: Module 2: Running Minimum
Online Diagnostics...
Jun  6 19:27:10 SAST: %DIAG-SP-6-DIAG_OK: Module 2: Passed Online
Diagnostics
Jun  6 19:27:10 SAST: %OIR-SP-6-INSCARD: Card inserted in slot 2, interfaces
are now online

The 6506 is running IOS sup22-jk2sv-mx.121-26.E5.

Software bug, or faulty hardware ?? 

Kind Regards,
Chris.



_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/