[c-nsp] optic diag commands on 6500

[chip]

show transceiver interface module <module number>

--chip

On Fri, Jun 10, 2011 at 3:27 PM, Mandeep Singh <s_mandeep at hotmail.com> wrote:
>
> Hi,
> Is there a similar command on the 6500s as on the Junipers below:
>
>  show interfaces diagnostics optics xe-0/0/8
> Physical interface: xe-0/0/8
>    Laser bias current                        :  39.304 mA
>    Laser output power                        :  0.7050 mW / -1.52 dBm
>    Module temperature                        :  41 degrees C / 106 degrees F
>    Module voltage                            :  3.2490 V
>    Receiver signal average optical power     :  0.1063 mW / -9.73 dBm
> Thanks.
> -Mandeep
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>



-- 
Just my $.02, your mileage may vary,  batteries not included, etc....