[c-nsp] optic diag commands on 6500

[Jared Mauch]

Router#    sh int t6/1 transceiver 
ITU Channel not available (Wavelength not available),
Transceiver is internally calibrated.
If device is externally calibrated, only calibrated values are printed.
++ : high alarm, +  : high warning, -  : low warning, -- : low alarm.
NA or N/A: not applicable, Tx: transmit, Rx: receive.
mA: milliamperes, dBm: decibels (milliwatts).

                                         Optical   Optical
            Temperature  Voltage  Current   Tx Power  Rx Power
Port        (Celsius)    (Volts)  (mA)      (dBm)     (dBm)
----------  -----------  -------  --------  --------  --------
Te6/1         25.2       0.00       0.0       N/A       N/A   

On Jun 10, 2011, at 3:27 PM, Mandeep Singh wrote:

> 
> Hi,
> Is there a similar command on the 6500s as on the Junipers below:
> 
> show interfaces diagnostics optics xe-0/0/8 
> Physical interface: xe-0/0/8
>    Laser bias current                        :  39.304 mA
>    Laser output power                        :  0.7050 mW / -1.52 dBm
>    Module temperature                        :  41 degrees C / 106 degrees F
>    Module voltage                            :  3.2490 V
>    Receiver signal average optical power     :  0.1063 mW / -9.73 dBm
> Thanks.
> -Mandeep 		 	   		  
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/