[c-nsp] RBE on SIP-400

[Tony]

Hi all,

Just for the archives the answer is to bridge the ATM PVC to a VLAN interface. Thanks to the offlist response to help me sort this out (Joe).

Eg

interface ATM4/0/1.300 point-to-point
 pvc 1/300 
  bridge-domain abcd
  vbr-nrt 2048 2048 1
  encapsulation aal5snap

interface Vlan abcd
 ip vrf forwarding red
 ip address aaa.bbb.ccc.ddd www.xxx.yyy.zzz



regards,
Tony.

--- On Thu, 23/6/11, Tony <td_miles at yahoo.com> wrote:

> From: Tony <td_miles at yahoo.com>
> Subject: [c-nsp] RBE on SIP-400
> To: cisco-nsp at puck.nether.net
> Received: Thursday, 23 June, 2011, 10:14 PM
> Hi all,
> 
> I have some services from a carrier that are being hand off
> as a PVC with routed bridge encapsulation - RBE (via an
> STM-1).
> 
> This is connected to a 7609 with SIP-400 &
> SPA-4XOC3-ATM, running 12.2(33)SRD4.
> 
> It would appear that the command "atm route-bridge ip" is
> only supported on ATM cards in the SIP-200  (I have no
> idea WHY this limitation !).
> 
> I definitely require RBE to terminate the service as I have
> tried it on an old 7204 and it worked fine with "atm
> route-bridge ip" enabled on the interface.
> 
> Does anyone have suggestions or workarounds to get this
> working on the hardware I currently have in the 7609 ?
> 
> 
> Thanks,
> Tony.
> 
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>