[c-nsp] Timing question on a 2620 XM

[james edwards]

I have not run across the commands "network-clock-XXXXX" on a 2600. I want
to clock off this T-1 (clock source line):


!
interface ATM0/0
 description Circuit ID#
 no ip address
 ip route-cache flow
 no atm ilmi-keepalive
!
interface ATM0/0.32 point-to-point
 description T1 ATM to JID Core
 ip address x.x.x.x/30
 ip access-group 100 out
 ip mroute-cache
 pvc 1/32
  cbr 1536
  encapsulation aal5snap


Is this the correct config: ?

network-clock-participate wic 0
network-clock-participate aim 0
network-clock-select 1 T1 0/0


Do I still set timing here (ie clock source line) ?


controller T1 0/0
 mode atm aim 0
 framing esf
 linecode b8zs


IOS is 122-8.T10 on a 2620 XM.

There is only one T-1 on the router, atm0/0.


Thanks,

-- 
James H. Edwards
Network Systems Administrator
Judicial Information Division
jedwards at nmcourts.gov
James H. Edwards
Network Systems Administrator
Judicial Information Division
jedwards at nmcourts.gov