[c-nsp] Fwd: GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for GBIC in port [dec]

[chip]

It also could be the version of SW doesn't support this particular
pluggable.  Go poke around on Cisco's site to check.

--chip

On Mon, May 23, 2011 at 4:29 PM, David Prall <dcp at dcptech.com> wrote:
> It is "service unsupported-transceiver" it is hidden so tab completion won't
> help you.
>
> cat3560-1(config)#service unsupported-transceiver
>  Warning: When Cisco determines that a fault or defect can be traced to
> the use of third-party transceivers installed by a customer or reseller,
> then, at Cisco's discretion, Cisco may withhold support under warranty or
> a Cisco support program. In the course of providing support for a Cisco
> networking product Cisco may require that the end user install Cisco
> transceivers if Cisco determines that removing third-party parts will
> assist Cisco in diagnosing the cause of a support issue.
>
> cat3560-1(config)#no service unsupported-transceiver
>
> David
>
> --
> http://dcp.dcptech.com
>
>
>> -----Original Message-----
>> From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-
>> bounces at puck.nether.net] On Behalf Of Dennis
>> Sent: Monday, May 23, 2011 4:15 PM
>> To: cisco-nsp at puck.nether.net
>> Subject: [c-nsp] Fwd: GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification
>> check failed for GBIC in port [dec]
>>
>> I'm out of my element at this point - does anyone else have any
>> suggestions?
>>
>>
>> ---------- Forwarded message ----------
>> From: Farooq Razzaque <farooq_mcp at hotmail.com>
>> Date: Mon, May 23, 2011 at 1:05 PM
>> Subject: RE: [c-nsp] GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification
>> check failed for GBIC in port [dec]
>> To: daodennis at gmail.com
>>
>>
>> Dear Dennis
>>
>> I tried the following command but this command is not support. can u
>> please check again and let me know
>>
>> service-unsupported transceiver
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> > Date: Mon, 23 May 2011 09:31:58 -0700
>> > Subject: Re: [c-nsp] GBIC_SECURITY_CRYPT-4-ID_MISMATCH:
>> Identification check failed for GBIC in port [dec]
>> > From: daodennis at gmail.com
>> > To: farooq_mcp at hotmail.com
>> >
>> > On Mon, May 23, 2011 at 9:30 AM, Farooq Razzaque
>> <farooq_mcp at hotmail.com> wrote:
>> > > Dear Dennis
>> > >
>> > > Is there need to upgrade the IOS ?
>> >
>> > I don't know for sure. Are you using Cisco SFPs? What IOS is it?
>> >
>> >
>> > >
>> > > service-unsupported transceiver
>> > >
>> > > Do i need to put the following commands as well or only the above
>> command
>> > > will be sufficient.
>> >
>> > Just try the above if that doesn't work put in the below commands as
>> well.
>> >
>> > >
>> > > no errdisable detect cause gbic-invalid
>> > >  errdisable recovery cause all
>> > >  errdisable recovery interval 30
>> > >
>> >
>> > Thanks,
>> >
>> > Dennis O.
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >
>> > >> Date: Mon, 23 May 2011 09:27:51 -0700
>> > >> Subject: Re: [c-nsp] GBIC_SECURITY_CRYPT-4-ID_MISMATCH:
>> Identification
>> > >> check failed for GBIC in port [dec]
>> > >> From: daodennis at gmail.com
>> > >> To: farooq_mcp at hotmail.com
>> > >>
>> > >> On Mon, May 23, 2011 at 9:26 AM, Farooq Razzaque
>> <farooq_mcp at hotmail.com>
>> > >> wrote:
>> > >> > Dear Dannis
>> > >> >
>> > >> > Thanks for your reply
>> > >> >
>> > >> > Is there any need to upgrade the IOS ?
>> > >> >
>> > >> > Are the following commands will be put on the GBIC interface
>> > >>
>> > >> Just do it in global config mode.
>> > >
>>
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>



-- 
Just my $.02, your mileage may vary,  batteries not included, etc....