[c-nsp] ZBFW and DHCP

[Hughes, Scott GRE-MG]

Did you setup any zone-pairs involving the 'self' zone? If you don't use self zones, no additional configuration should be necessary for DHCP packets. 



On Sep 12, 2011, at 9:43 AM, "Scott Voll" <svoll.voip at gmail.com> wrote:

> So I'm setting up a GRE IPSEC tunnel as my backup link with a 2821.  I have
> also setup ZBFW on the outside interface.  So far so good.
> 
> BUT now the outside interface will not get a DHCP address from the ISP.  How
> do I allow the Router to get a DHCP address?  Did I miss something on the
> ZBFW config?  Or can this not be done?
> 
> TIA
> 
> Scott
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/


NOTICE TO RECIPIENT: The information contained in this message from
Great River Energy and any attachments are confidential and intended
only for the named recipient(s). If you have received this message in 
error, you are prohibited from copying, distributing or using the
information. Please contact the sender immediately by return email and
delete the original message.