[c-nsp] ASR9K bundle-id 123 mode on

[adam vitkovsky]

Hi Folks,
The "on" keyword means LACP is not run over the port -at least that's what
documentation says
So how the heck does the port know that the other end is not configured for
LACP ???

I'm starting to test the MLACP and don't have the CE hanging of the ASR9Ks
yet so I thought I'd configure the interfaces with "loopback internal" so
they'd come up and than I've added them to bundle
Well...  what I got afterwards on both ASR9Ks is: Interface
GigabitEthernet0/2/0/2 in Bundle-Ether3 is incompatible with the active
bundle members; link is not using LACP but active bundle members are
Even though Gig0/2/0/2 is the only interface in the bundle on a particular
ASR9K 

Bundle-Ether3
  Status:                                    Down
  Local links <active/standby/configured>:   0 / 0 / 1
  Local bandwidth <effective/available>:     0 (0) kbps
  MAC address (source):                      0010.0010.0010 (Configured)
  Minimum active links / bandwidth:          1 / 1 kbps
  Maximum active links:                      64
  Wait while timer:                          2000 ms
  Load balancing:                            Default
  LACP:                                      Operational
    Flap suppression timer:                  Off
    Cisco extensions:                        Disabled
  mLACP:                                     Operational
    ICCP Group:                              1
    Role:                                    Active
    Foreign links <active/configured>:       0 / 1
    Switchover type:                         Non-revertive
    Recovery delay:                          300 s
    Maximize threshold:                      1 link
  IPv4 BFD:                                  Not configured

  Port                  Device           State        Port ID         B/W,
kbps
  --------------------  ---------------  -----------  --------------
----------
  Gi0/2/0/2             Local            Configured   0x8000, 0x9004
1000000
      Incompatible with other links in the bundle (LACP vs non-LACP)
  Gi0/2/0/2             10.1.1.4         Configured   0x8000, 0xa004
1000000
      Link is down



do sh bundle stat
Tue Aug  7 22:32:05.784 UTC
Checking configuration...

  Cross checking configuration with bundle
database..........................OK

  Checking configuration
setup...............................................OK

Checking configuration
result................................................OK
----------------------------------------------------------------------------
---
Checking operational state...

  Checking local system
operation............................................OK

  Checking for mLACP
inconsistencies.........................................OK

  Checking mLACP operation...

    ICCP Group 1:
      Bundle-Ether3 (Not operational):
        WARNING: Bundle is down on local device 
        Device Local:
          WARNING: Not enough selectable links to be operational
          WARNING: Bundle is down on peer device 10.1.1.4
        GigabitEthernet0/2/0/2 (Not active):
          WARNING: Member state TLV reported error on local device 
          Device Local:
            WARNING: Incompatible with other links in the bundle (LACP vs
                     non-LACP)
        Gi0/2/0/2 (Not active):
          INFO: Member is down on peer device 10.1.1.4

  Checking mLACP operation
result.......................................WARNING






adam