[c-nsp] me3600 svi's not showing in and out bit counts that i see on corresponding phy int

[Andrew K.]

Would be great if multicast worked corrected through the efp.

On 8/9/2012 10:19 AM, Aaron wrote:
> Thanks Reuben.  By efp's, I take it you mean the command structure for
> Ethernet service instance, bride domain, etc.  right ?
>
> Aaron
>
> -----Original Message-----
> From: Reuben Farrelly [mailto:reuben-cisco-nsp at reub.net]
> Sent: Wednesday, August 08, 2012 3:51 PM
> To: Aaron
> Cc: cisco-nsp at puck.nether.net
> Subject: Re: [c-nsp] me3600 svi's not showing in and out bit counts that i
> see on corresponding phy int
>
> It seems to be an architecture thing - this has been the case across all of
> the code drops on this platform so far to date.  I suspect only process
> switched data is counted in those interfaces.
>
> You'll need to poll EFP's on these switches instead of VLAN interfaces for
> measuring data flows - those are per-service+per-port and the SNMP counters
> on those do get populated.  And if you're not yet using EFP's then you're
> probably not using these switches to their full potential :-)
>
> Reuben
>
>
> On 8/08/2012 11:54 PM, Aaron wrote:
>> anybody know why me3600 svi doesn't seem to show in and out bit counts
>> that the underlying phy int shows?  ....all svi's (10,11,13) are in a
>> vrf running over mpls l3vpn
>
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>