[c-nsp] me3600 svi's not showing in and out bit counts that i see on corresponding phy int

[Aaron]

Thanks Reuben.  By efp's, I take it you mean the command structure for
Ethernet service instance, bride domain, etc.  right ?

Aaron

-----Original Message-----
From: Reuben Farrelly [mailto:reuben-cisco-nsp at reub.net] 
Sent: Wednesday, August 08, 2012 3:51 PM
To: Aaron
Cc: cisco-nsp at puck.nether.net
Subject: Re: [c-nsp] me3600 svi's not showing in and out bit counts that i
see on corresponding phy int

It seems to be an architecture thing - this has been the case across all of
the code drops on this platform so far to date.  I suspect only process
switched data is counted in those interfaces.

You'll need to poll EFP's on these switches instead of VLAN interfaces for
measuring data flows - those are per-service+per-port and the SNMP counters
on those do get populated.  And if you're not yet using EFP's then you're
probably not using these switches to their full potential :-)

Reuben


On 8/08/2012 11:54 PM, Aaron wrote:
> anybody know why me3600 svi doesn't seem to show in and out bit counts 
> that the underlying phy int shows?  ....all svi's (10,11,13) are in a 
> vrf running over mpls l3vpn