[c-nsp] Moving Routing from 7206VRX to 6509-E

[An Nguyen]

Thanks.
 
So by default, if DFC is installed, ingress and egress on the same fabric-enabled module, everything is good. If egress is on a different fabric-enabled module, it is still not going through supervisor engine? 
Does it only goes through supervisor engine if egress or ingress is on a non frabric enabled module?

>>> 


From: Phil Mayers <p.mayers at imperial.ac.uk>
To:<cisco-nsp at puck.nether.net>
Date: 12/12/2012 8:59 AM
Subject: Re: [c-nsp] Moving Routing from 7206VRX to 6509-E
On 12/12/12 14:41, An Nguyen wrote:
> One question I have been pondering on is how to configure the DFC4
> cards so that routing/switching traffic for VLANs on the chassis
> doesn't go through the Supervisor Engine 2T.

There's no config. It's automatic - if you install a DFC on a linecard, 
that DFC is used to perform forwarding for any packet which ingresses on 
that linecard.
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

If you need to provide Emprise Bank with sensitive information such as account numbers, social security numbers, pin numbers, user names, or passwords, please use our secure email site at https://securemail.emprisebank.com. This site will encrypt and send the information securely. 

For your protection, do not submit sensitive information about yourself via non-secure email. Information sent without the use of the secure email site is not encrypted, and we cannot guarantee your privacy. 

This communication is intended only for the person or entity to which it is addressed. If you are not the intended recipient, you may not make use of the enclosed information in any way. Please notify Emprise Bank of the error immediately and delete the email from your computer.