[c-nsp] Cisco command to see active session on "cisco WS-C6503-E (R7000)"

[Raymond Burkholder]

> 
> > You need netflow enabled on the switch, then enable "ip flow ingress"
and
> "ip flow egress" on the interface you are interested in, then perform a
"show
> ip cache flow"
> 
> In addition to all the caveats which render pre-Sup2T/DFC4 NetFlow on 6500
> extremely problematic, one ought never under any circumstances to enable
> both ip flow ingress and ip flow egress on the same interface.
> 
> Instead, use one or the other.  But not both.
> 

Why?  Is this detrimental?  It would seem to be a likely configuration
possibility if one has many 'local' links and only one or two 'outside'
aggregate links.  It would be easier to configure just ingress/egress on the
couple, rather than ingress on all of them.  And from a documentation
perspective, would make things clear what was happening.


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.