[c-nsp] 10Gigabit Ethernet with Sup6L-E

[Alex D.]

Hi list,

i have a problem with some a WS-C4506-E chassis.
The systems doesn't boot when 1 or both 10G ports are equiped with a X2 
transceiver. All status LEDs remain dark.
When i power-on the supervisor engine without transceivers, system boots 
successful. After reinserting a transceiver, system dies without any 
console output.
If i use TwinGig converters, system works without problems.

Are there any restictions, when using Sup6L-E with 10G ports ?

Regards,
Alex


Switch#sh ver
Cisco IOS Software, Catalyst 4500 L3 Switch Software 
(cat4500e-LANBASE-M), Version 12.2(54)SG, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Sun 27-Jun-10 08:37 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x12823FA8

ROM: 12.2(44r)SG5
Darkside Revision 4, Nexu Revision 9, Fortooine Revision 1.22

Switch uptime is 6 hours, 58 minutes
System returned to ROM by reload
System image file is "bootflash:cat4500e-lanbase-mz.122-54.SG.bin"
Last reload reason: Unknown reason


cisco WS-C4506-E (MPC8548) processor (revision 9) with 524288K bytes of 
memory.
Processor board ID FOX1443G9E1
MPC8548 CPU at 1GHz, Supervisor 6L-E
Last reset from Reload
1 Virtual Ethernet interface
124 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.

Configuration register is 0x2101