[c-nsp] 10Gigabit Ethernet with Sup6L-E

[Piotr Wojciechowski]

On 1/25/12 20:39 , Alex D. wrote:
> Hi list,
> 
> i have a problem with some a WS-C4506-E chassis.
> The systems doesn't boot when 1 or both 10G ports are equiped with a X2
> transceiver. All status LEDs remain dark.
> When i power-on the supervisor engine without transceivers, system boots
> successful. After reinserting a transceiver, system dies without any
> console output.
> If i use TwinGig converters, system works without problems.
> 
> Are there any restictions, when using Sup6L-E with 10G ports ?
> 

Hi Alex,

Might be some hardware problem with either supervisor (more likely) or
X2 transceivers itself (less likely). Have you tried inserting different
X2 transceivers or using same one in different chassis?

Regards,


-- 
Piotr Wojciechowski  (CCIE #25543)  | "The trouble with being a god is
http://ccieplayground.wordpress.com | that you've got no one to pray to"
JID: peper at jabber.org               |   -- (Terry Pratchett, Small Gods)