[c-nsp] acl on bvi in ios xr (9k) 4.1.2

[Tassos Chatzithomaoglou]

Many things missing....



http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42irb.html#wp1011723

The following areas are /not/ supported on the BVI:

–Access Control Lists (ACLs). However, Layer 2 ACLs can be configured on each Layer 2 port 
of the bridge domain.

–IP fast reroute (FRR)

–NetFlow

–MoFRR

–MPLS label switching

–mVPNv4

–Quality of Service (QoS)

–Traffic mirroring

–Unnumbered interface for BVI

–Video monitoring (Vidmon)



--
Tassos

chip wrote on 19/7/2012 19:45:
> interface BVI101
>   description cust-bgp-1 vlan 101
>   ipv4 address x.x.x.x 255.255.255.252
>   ipv4 access-group cust-bgp-1-out-acl egress
>
> This is gained support in 4.2.0 I think.
>
> --chip
>
> On Thu, Jul 19, 2012 at 12:39 PM, Aaron <aaron1 at gvtc.com> wrote:
>> Are acl's supported on BVI's ?
>>
>> I have a phy int g0/0/0/1 with a flow point (sub int) g0/0/0/1.10
>> l2transport config'd and put into l2vpn bg:bd with a routed int inside that
>> bg:bd as bvi 10
>>
>>
>>
>> I would think that the appropriate location to place an ipv4 access-list
>> would be on the L3 interface , that being the bvi.  But I don't see the
>> command "ipv4 access-list" under the bvi.
>>
>>
>>
>> What am I missing here ?
>>
>>
>>
>> Aaron
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> _______________________________________________
>> cisco-nsp mailing list  cisco-nsp at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-nsp
>> archive at http://puck.nether.net/pipermail/cisco-nsp/
>
>