[c-nsp] GSR PRP2 Management Interface Configuration

[Xu Hu]

Thanks Oil, my GSR used IOS, that's why cannot check the interface of
Standby RP.

2012/6/5 Oliver Boehmer (oboehmer) <oboehmer at cisco.com>

>
> > My GSR have two PRP2, each PRP has three management interface which
> can be
> > configured IP address.
> > But the thing is through show ip interface brief, i just can see three
> > Ethernet interface, cannot see six Ethernet.
> > Now my issue is if i configure the E0 interface as ip address
> > 192.168.1.1/24,
> > when the active PRP down, will the configuration change to the standby
> PRP?
>
> In IOS, the ports on the standby PRP will be inactive, there is no IP
> address configured on them, hence you only see the ports from the active
> RP, and when the standby takes over as active, it will (obviously) use
> the same addresses.
>
> This is different from IOS-XR where the standby ports are visible and
> active, and which require an IP address, using the virtual-address as a
> mechanism to reach the management-interface by the same address, no
> matter which RP is active.
>
>        oli
>
>