[c-nsp] IPv6 Etherchannel Workaround for 7600 15.2 (Configuration Concerns)

[Xu Hu]

Lol, finally got this point. Will try to test in the real router.

Appreciate for all the experts' reply and help.

2012/6/27 Gert Doering <gert at greenie.muc.de>

> Hi,
>
> On Wed, Jun 27, 2012 at 12:09:10PM +0800, Xu Hu wrote:
> > Since IPv6 Etherchannel cannot support for Cisco IOS so far, one of the
> > solution is using the GRE tunnel sending traffic through port-channel,
> > hence using the bandwidth.
>
> IPv6 on Etherchannels works perfectly well in general.  Just on specific
> combinations of hardware and line cards (AFAIR, GSR with some line cards)
> it's not yet supported.
>
> > My IPv6 new deployment is dual-stack, since my IPv4 Etherchannel have
> many
> > sub-interface configuration and also the EVC configuration (Using ES+
> line
> > card for Port-channel), now i am wondering how to configure such parts
> when
> > IPv6 is deploying.
>
> If you have an ES+ line card, you have 7600, and these have no restrictions
> regarding IPv6 on channels.
>
> > Using sub-interface under Tunnel?
>
> Don't believe everything the "experts" say :-)
>
> gert
> --
> USENET is *not* the non-clickable part of WWW!
>                                                           //
> www.muc.de/~gert/
> Gert Doering - Munich, Germany
> gert at greenie.muc.de
> fax: +49-89-35655025
> gert at net.informatik.tu-muenchen.de
>