[c-nsp] Cisco BFD

[Adam Vitkovsky]

I came to conclusion that bfd doesn't work in dynamips it will always crash


adam
-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net
[mailto:cisco-nsp-bounces at puck.nether.net] On Behalf Of M K
Sent: Tuesday, November 06, 2012 2:43 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Cisco BFD


Hi allI was trying to configure BFD with OSPF

I have the below configuration R1#sh run int f0/0.519Building
configuration...
Current configuration : 112 bytes!interface FastEthernet0/0.519
encapsulation dot1Q 519 ip address 20.5.19.19 255.255.255.0 ip ospf bfdend
R5#sh run int f0/0.519Building configuration...
Current configuration : 111 bytes!interface FastEthernet0/0.519
encapsulation dot1Q 519 ip address 20.5.19.5 255.255.255.0 ip ospf bfdend
R5#sh ip ospf neighbor | inc 51919.19.19.19       1   FULL/DR
00:00:39    20.5.19.19      FastEthernet0/0.519
I have no bfd neighbors
R5#sh bfd neighbors R5#
As well , am using GNS3 , when i tried to modify the BFD timers , The
routers stuck with no responseinterface FastEthernet0/0.519ip ospf bfdbfd
interval 250 min_rx 250 multiplier 3
Any ideas?Thanks 		 	   		  
_______________________________________________
cisco-nsp mailing list  cisco-nsp at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/