[c-nsp] 2960G upgrade to 150-2 no link on SFP?

Mike mike-cisconsplist at tiedyenetworks.com
Fri Nov 16 16:28:07 EST 2012


On 11/16/2012 12:49 PM, CiscoNSP_list CiscoNSP_list wrote:
>
>
> Hi Guys,
>
> Upgraded a 2960G to c2960-lanbasek9-mz.150-2.SE.bin and now the single mode SFP wont link - Config is the same?
> Other end of the fibre is a carrier switch, and they are seeing up/up:
> Full-duplex, 1000Mb/s, link type is force-up, media type is 1000BaseLX SFP
> We see down/down:
> GigabitEthernet0/45 is down, line protocol is down (notconnect)
>    Hardware is Gigabit Ethernet, address is 0024.c3f0.912d (bia 0024.c3f0.912d)
>
>    Description: GIGE_ICAP_INTERNETCONNECT
>
>    MTU 1998 bytes, BW 10000 Kbit/sec, DLY 1000 usec,
>
>       reliability 255/255, txload 1/255, rxload 1/255
>
>    Encapsulation ARPA, loopback not set
>
>    Keepalive not set
>
>    Auto-duplex, Auto-speed, link type is auto, media type is 1000BaseLX SFP
>
>
>
Change your config to force speed, duplex and force-up, that should fix 
it for you.

Mike-


More information about the cisco-nsp mailing list