[c-nsp] QoS (dscp-to-exp mutation) on Sup-2T/Cat6500

[Tóth András]

Hi Alex,

The command is hidden, as far as I know because it is not supported and
replaced by "table-maps". If you press enter after "platform qos map" it
will say incomplete command, so it's still there but hidden.

You could use the "table-map" command instead and "show table-map" to
verify the config. Details in the guide below:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/15.0SY/configuration/guide/qos_global_and_if.html

Best regards,
Andras


On Thu, Nov 29, 2012 at 3:45 PM, Alex K. <nsp.lists at gmail.com> wrote:

> Hi All,
>
> I ran into interesting issue on Sup-2T. As you probably know, QoS CLI is
> changed on this new supervisor. I'm looking to translate incoming
> dscp-marked packets, into exp-marked on egress.
> Now, according to documentation - Catalyst 6500 Release 15.0SY Software
> Configuration Guide<
> http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/15.0SY/configuration/guide/15_0_sy_swcg.html
> >-
> this functionality is still called mutation-map and is configured
> under
> 'platform qos map exp-mutation'. The problem is quite simple – there is no
> 'platform qos map exp-mutation' on 2 different machines I checked upon.
> Here:
>
> Some-6513(config)#platform qos ?
>   10g-only qos pure 10G mode
>   aggregate-policer Named aggregate policer
>   marking marking keyword
>   police police keyword
>   protocol protocol keyword
>   queueing-only queueing-only (no QoS rewrite, no policing)
>   rewrite packet qos rewrite enable/disable
>   statistics-export qos statistics data export
>
>
> What do you think I'm missing?
>
> Alex.
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>