[c-nsp] cisco 3825 and wccp

[Curtis LaMasters]

I have this working with roughly 35 megs of traffic to a Barracuda Web
Filter.  CPU on router is at 37% but I also run NAT on there.  No issues.

Curtis LaMasters
http://www.curtis-lamasters.com


On Mon, Oct 15, 2012 at 1:55 PM, null zeroroute <nullzero.route at gmail.com>wrote:

> Anyone have any experience with running WCCPv2 on a Cisco 3825?
>
> The router will have two gig-e intertfaces, one will have a dozen or so
> sub-interfaces, traffic routing from one physical interface to the other.
> No routing protocols, no NAT, no IPSec, etc... just a simple router with
> WCCP v2 enabled.
>
> I'm probably looking at average utilization somewhere around 50 Mbps, with
> intermittent short lived spikes up to ~90 Mbps.  Probably less then half
> that traffic would be subjected to WCCP redirection, HTTP only.
>
> My only experience with WCCP has been on the 6500 platform with sup720-3b's
> sending to some BlueCoat boxes and that's been running well, just wasn't
> sure if there was anything to be concerned about with the level of traffic
> noted above on a 3825.
>
> Any feedback is appreciated.
>
> Thanks,
>
> --NZR
> _______________________________________________
> cisco-nsp mailing list  cisco-nsp at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/
>