[c-nsp] EoMPLS with WS-X6724 and WS-X6704-10GE

[zaid]

hi 

I tried with port based but i get the same result , and for subinterface I wont go with it 
here is the output 

sh mpls l2transport vc 777 detail
Local interface: Vl666 up, line protocol up, Eth VLAN 666 up
  MPLS VC type is Eth VLAN, interworking type is Ethernet
  Destination address: 10.100.100.23, VC ID: 777, VC status: down
    Output interface: if-?(0), imposed label stack {}
    Preferred path: not configured
    Default path: no route
    No adjacency
  Create time: 00:20:49, last status change time: 00:00:00
  Signaling protocol: LDP, peer 10.100.100.23:0 up
    Targeted Hello: 10.100.100.4(LDP Id) -> 10.100.100.23
    MPLS VC labels: local 456, remote unassigned
    Group ID: local 0, remote unknown
    MTU: local 1500, remote unknown
    Remote interface description:
  Sequencing: receive disabled, send disabled
  VC statistics:
    packet totals: receive 0, send 0
    byte totals:   receive 0, send 0
    packet drops:  receive 0, send 0

I followed the config from this link :

http://www.cisco.com/en/US/docs/ios/12_1/12_1ex/feature/guide/eompls9.html#wp1119431

thanks


________________________________
 From: zaid <zaidoon_h at yahoo.com>
To: "cisco-nsp at puck.nether.net" <cisco-nsp at puck.nether.net> 
Sent: Wednesday, October 31, 2012 9:12 AM
Subject: EoMPLS with WS-X6724 and WS-X6704-10GE
 

Hi 

I can't  deploy EoMpls between two routers7600 (R1 WS-X6724 facing core,R2 WS-X6704-10GE facing core) while  between two routers (WS-X6724 facing core) the PW is up and running , is there any HW restrictions .

Regards

Zaid