[c-nsp] 3560g switch - tagged vlans and untagged frames

Jeff Kell jeff-kell at utc.edu
Tue Apr 9 00:30:52 EDT 2013

On 4/9/2013 12:16 AM, Mike wrote:
> It it helps. I do also have dot1q native vlan tagging enabled. I just
> can't see inside of the switch and understand where my frames are
> going. If I put it into switchport mode access, and switchport access
> vlan 6, it all works fine and I see mac addresses in the table.

If you enable native vlan tagging, it will drop any untagged frames.


More information about the cisco-nsp mailing list